Camera Control Unit - Hamamatsu Photonics C8484-16C Instruction Manual

6-2

CAMERA CONTROL UNIT

①
① Camera head extension connector
Connector used for connecting the camera head to the camera control unit.
② Camera connector [POWER]
Connector used for connecting the camera head to the AC adaptor.
Note
③ Camera mount
Jig for fixing the camera head. Used when mounting the camera control unit on a tripod or
other fixture.
④ Serial interface connector [SERIAL I/F]
⑤ CameraLink interface connector [DIGITAL OUT]
Connector used for connecting the camera control unit to the CameraLink interface board.
⑥ Timing I/O connector [TIMING I/O]
This connector is used for input and output of timing signals when synchronizing with external
equipment.
⑦ Mode switching switch
•
①
• The AC adaptor in an option. Use the recommendation article of Hamamatsu.
• Do not connect it. Because this is a connector for the camera maintenance.
Do not change this. All positions are set to "OFF".
C8484-16C Instruction manual Ver.1.5
③
Figure 6-2
④
⑤
⑥ ⑦ ②
9