Emerson Micro Motion 5700 Installation Manual page 39

3.1.6 Wire the I/O channel using an M12-terminated cable
(optional)
Use this procedure if you are using an M12-terminated cable to wire the I/O channel.
Prerequisites
Obtain an A-coded M12-terminated cable.
Procedure
1.
2.
Installation Manual
Attach the M12-terminated cable to the configuration I/O connector on the Model
5700 transmitter. See Figure
Attach the other cable end using the pinouts described in
Figure 3-12: M12-terminated cables to the Configuration I/O
Table 3-1: M12 configuration I/O pinouts
Pin identifica-
tion Wire color
Pin 1 Not used
Pin 2 White
Pin 3 Not used
Pin 4 Black
3-12.
Outputs
Not used
Positive terminal
Not used
Neutral terminal
Wiring the channels
Table 3-1.
35