Warnings And Cautions; General Warnings And Cautions - Newport SMC100CC User Manual

SMC100CC & SMC100PP
EDH0206En2042 – 04/16
1.2

Warnings and Cautions

The following are definitions of the Warnings, Cautions and Notes that may be used in
this manual to call attention to important information regarding personal safety, safety
and preservation of the equipment, or important tips.
Situation has the potential to cause damage to property or
equipment.
Additional information the user or operator should consider.
1.3

General Warnings and Cautions

The following general safety precautions must be observed during all phases of
operation of this equipment.
Failure to comply with these precautions or with specific warnings elsewhere in this
manual violates safety standards of design, manufacture, and intended use of the
equipment.
• Heed all warnings on the unit and in the operating instructions.
• To prevent damage to the equipment, read the instructions in this manual.
• Only plug the power supply to a grounded power outlet.
• Assure that the power supply is properly grounded to earth ground through the
grounding lead of the AC power connector
• Route power cords and cables where they are not likely to be damaged.
• Disconnect or do not plug in the AC power cord in the following circumstances:
– If the AC power cord or any other attached cables are frayed or damaged.
– If the power plug or receptacle is damaged.
– If the unit is exposed to rain or excessive moisture, or liquids are spilled on it.
– If the unit has been dropped or the case is damaged.
– If the user suspects service or repair is required.
• Keep air vents free of dirt and dust.
• Keep liquids away from unit.
• Do not expose equipment to excessive moisture (>85% humidity)
• Do not operate this equipment in an explosive atmosphere.
• Disconnect power before cleaning the Controller/Driver unit. Do not use liquid or
aerosol cleaners.
• Do not open the SMC100CC/PP Controller/Driver. There are no user-serviceable
parts inside.
• Return equipment to Newport Corporation for service and repair.
• Dangerous voltages associated with the 100-240 VAC power supply are present
inside the power supply. To avoid injury, do not touch exposed connections or
components while power is on.
• Follow precautions for static-sensitive devices when handling electronic circuits.
Single-Axis Motion Controller/Driver for DC or Stepper Motor
WARNING
Situation has the potential to cause bodily harm or death.
CAUTION
NOTE
2