Memory All Clear; Memory All Clear (Ram All Clear) - Sam4s ER-230 Operation And Program Manual

Memory All Clear

Before you use your Sam4S Electronic Cash Register for the first time, you must perform a memory
all clear to insure that all totals and counters are cleared and that the default program is installed.
CAUTION: The procedures described in this area are security sensitive. Clearing all or parts of
the memory may cause damage or loss to the program. Do not share this
information with unauthorized users and distribute the special SERVICE-Mode
key only to those you may want to perform these functions.
Perform "Clear All Totals", or "Clear PLU File" if you wish to clear only parts of memory.
Complete clearing of all memory areas and installation of the default program can be done through
the following special procedure:
ER-230 Memory All Clear (RAM All Clear)
To Perform a Memory All Clear (reset memory completely - ER-230
only):
1. Turn the power switch located on the right side of the register to the OFF position.
2. Press and hold the button position where the CHECK button is located on the default
keyboard layout.
3. Continue to hold the CHECK button while turning the power switch to the ON position.
4. After hear BEEP, release CHECK button, "ALL CLEAr" will appear on the display.
5. Press the upper left button (RECEIPT FEED) of the keyboard, then the lower left
button (CANCEL), then the upper right button (MODE), and finally press the lower
right button (CASH). "g"-"O"-"O"-"d" will appear on the display as you press each
button one by one.
RECEIP
T FEED
VOID
ERROR
CORR
RETURN
CANCEL
6. Display will show "= = = = = = = = = = = =" while proceeding.
7. When memory is cleared, the register prints a message "RAM ALL CLEAR OK!"
112 • Service Mode Programming
- CLEAR PLU
+%
7 8
-%
4 5
MACRO1
1 2
SCALE
0
00
X/TIME #/NS RA
9 1 5
6 2 6
3 3 7
. 4 8
Sam4S 230, 3xx, 4xx, 52xx Electronic Cash Register AU
PO CLERK
MODE
9 CHG1 CHG 2
10 CONV1
CHECK
11 SBTL
12 CASH