Default Program; Keyboard Configuration Program; Memory All Clear - Sam4s ER-5115II Operator's And Programming Manual

Default Program

The SAM4s ER-5115II arrives with a default or generic program already installed. Program options
are set to 0 (Zero), unless otherwise noted, which means the machine can be operated immediately
after a RAM clear procedure is performed.
For example:




Keyboard Configuration Program

The standard SAM4s 5115II keyboard is configured with 15 NLU keys. This keyboard can be
expanded to 40 NLU locations. This program is required if the keyboard is reconfigured.
Set to a 40 NLU Configuration
Set to a 15 NLU Configuration

Memory All Clear

1. Unplug the register.
2. Turn the control lock to the S position.
3. Press and hold the key position where the 00 key is located on the default keyboard
4. Continue to hold the 00 key while turning the power switch to the ON position.
6. After a short delay (3-5 seconds) the printer will print the message: "RAM ALL
92  Programming
All keyboard PLUs are nontaxable and open, without entry limits by default status
programming of "00000000".
All system options are set to 0 in default programming, unless otherwise noted.
Change only the options that will deviate from default programming. There is no need
to re-enter an option status of 0, since 0 is its original setting.
All programming (unless otherwise noted) is done with the control lock in the P
position. Each section details a specific area of register programming.
1. Turn the key lock to the S position.
2. Enter 40, press the X/TIME key.
3. Press CASH to finalize.
1. Turn the key lock to the S position.
2. Enter 15, press the X/TIME key.
3. Press CASH to finalize.
layout.
CLEAR !" Memory is cleared and the default program is installed.
SAM4s ER-5115II Electronic Cash Register v1.6