Operational Settings - Mitsubishi Electric FX3U-ENET-ADP User Manual

FX -ENET-ADP User's Manual
3U
6.6

Operational Settings

For operation of GX Works2, refer to Section 8.1.
List of operation setting
Setting
IP address
Subnet mask
pattern
Default router IP
address
Operation
setting
Communication data
code
Direct connection
(simple connection)
Find CPU function
1) IP Address settings
Set the IP address of the local station according to the specified input format (decimal or hexadecimal).
Setting range :0.0.0.1 to 223.255.255.254 (decimal)
It should be set so that the local station Ethernet adapter and the communicating external device have the
same class and subnet address.
Set the IP address after consulting a network administrator (the person who plans the network and
manages IP addresses).
2) Subnet mask pattern settings
Set the subnet mask pattern of the local station according to the specified input format (decimal or
hexadecimal).
Setting range :192.0.0.0 to 255.255.255.252 (decimal)
Set the subnet mask pattern after consulting a network administrator (the person who plans the network
and manages IP addresses).
When not using the subnet mask, set any of the following table values according to class.
Class
Class A
Class B
Class C
*1. Ethernet networks include small-scaled network systems where multiple devices are connected to
one Ethernet hub along with medium and large-scaled network systems where multiple small-scaled
networks are connected by routers, etc.
The subnet mask logically divides one network, where many devices are connected, into multiple
sub-networks to facilitate administration.
Caution
All devices on the same sub-network must have a common subnet mask.
3) Default router IP address settings
Set the IP address of the router to be used when the Ethernet adapter communicates with the target
device on another Ethernet network.
Set the value that satisfies the following conditions.
- Condition 1: The IP address class is either A, B or C.
- Condition 2: The subnet address of the default router is the same as that of the local station Ethernet
adapter.
- Condition 3: The host address bits are not all "0" or all "1".
Set the default router IP address after consulting a network administrator (the person who plans the
network and manages IP addresses).
Set the Ethernet adapter IP address.
Set the subnet mask pattern.
Set the default router IP address.
Select a communication data code used for MC protocol, "Binary code" or "ASCII code".
Select whether or not direct connection (simple connection) is used.
Select whether or not the find CPU function is used.
00.00.00.01 to DF.FF.FF.FE (hexadecimal)
*1
C0.00.00.00 to FF.FF.FF.FC (hexadecimal)
Mask value
Decimal
255.0.0.0
255.255.0.0
255.255.255.0
Description
Hexadecimal
FF.00.00.00
FF.FF.00.00
FF.FF.FF.00
6 Introduction of Functions
6.6 Operational Settings
39
1
2
3
4
5
6
7
8
9
A