Direct Mounting - Mitsubishi Electric FX3U-ENET-ADP User Manual

FX -ENET-ADP User's Manual
3U
4.3

Direct mounting

When the Ethernet adapter is connected to a FX
panel surface using screws. The direct mounting method is not available when the Ethernet adapter is
connected to a FX
surface.
For mounting, refer to the following manual.
1
Create mounting holes in the
mounting surface according to the
external dimensions diagram.
2
Fit the Ethernet adapter to the
mounting holes and tighten with
M4 screws (A in the figure on the
right).
Also fit the main unit to the mounting holes
and tighten with M4 screws. For the main unit
connection method, refer to the following.
→ Refer to FX
It is assumed that the Ethernet adapter has
been connected in advance.
For the Ethernet adapter connection method,
refer to the following.
For the screw positions and number of screws in the Ethernet adapter, refer to the dimensional
outline drawing as follows.
For the screw positions and number of screws in the main unit, refer to the following manual.
28
PLC. Connect the Ethernet adapter to the main unit before attaching it to the panel
3UC
Hardware Edition
3U
PLC, the Ethernet adapter may be mounted directly on a
3U
→ Refer to FX
A
A
→ Refer to FX
4 Installation
4.3 Direct mounting
Hardware Edition
3U
→ Refer to Section 4.1
→ Refer to Section 1.2
Hardware Edition
3U