General Specifications; Power Supply Specifications; Communication Specification - Mitsubishi Electric FX3U-ENET-ADP User Manual

FX -ENET-ADP User's Manual
3U
2.1

General Specifications

For items not listed below, specifications are the same as those of the PLC main unit.
For general specifications, refer to the manual of the PLC main unit.
Item
Dielectric withstand voltage
Insulation resistance
2.2

Power Supply Specifications

Adapter driving power supply
Permitted instantaneous power failure time
2.3

Communication Specification

Item
Transmission specifications
Connector
*1. The value indicates the number of connectable stages when the repeater hub is used.
Contact the manufacturer of the switching hub for the number of connectable stages when using the
switching hub.
When connecting Ethernet adapter to a network, either a 10BASE-T or 100BASE-TX can be used.
The Ethernet adapter can be connected directly to the personal computer without using the hub.
The ports must comply with the IEEE802.3 10BASE-T or IEEE802.3 100BASE-TX standards.
Caution
• The Ethernet adapter detects whether it is 10BASE-T or 100BASE-TX, and full-duplex or half-duplex
transmission mode according to the hub. (auto detection function)
For connection to the hub without the auto detection function, set half-duplex mode on the hub side.
• The module operation is not guaranteed if any of the following connections are used.
- Connections using the Internet (general public line) (Connections using Internet connection service
provided by Internet service providers and telecommunications carriers)
- Connections using devices in which a firewall is installed
- Connections using broadband routers
- Connections using wireless LAN
500 V AC for one minute
5 M or more by 500 V DC Megger
Item
30mA / 5V DC
5V DC power is supplied internally from the main unit.
Same as connected PLC
Data transmission speed
Communication method
Transmission method
Maximum segment length
Maximum number of
nodes/connection
RJ45
→ Refer to FX
→ Refer to FX
Specification
Between PLC all terminals and ground terminal
Specification
Specification
100Mbps/10Mbps
Full-duplex/Half-duplex
Base band
100m (328'1")
10BASE-T
Cascade connection maximum 4 stages
100BASE-TX
Cascade connection maximum 2 stages
2 Specification
2.1 General Specifications
Hardware Edition.
3U
Hardware Edition.
3UC
*1
*1
19
1
2
3
4
5
6
7
8
9
A