Fx 3U -Enet-Adp Connection - Mitsubishi Electric FX3U-ENET-ADP User Manual

FX -ENET-ADP User's Manual
3U
4.1 FX -ENET-ADP Connection
3U
An expansion board should be installed before connecting the Ethernet adapter. An expansion board is not
required when the Ethernet adapter is connected to a FX
This section explains an example where the Ethernet adapter is connected to a FX
another PLC, refer to the respective PLC manual.
1
Remove the special adapter connector cover
(A in the figure on the right) from the expansion
board.
It is assumed that an expansion board has been installed in
advance. For the expansion board installation method, refer
to the respective PLC manual.
2
Slide the special adapter connecting hooks
(B in the figure on the right) of the main unit
upwards.
3
Connect the Ethernet adapter (C
in the figure on the right) to the
main unit as shown in the figure
on the right.
4
Slide the special adapter
connecting hooks (B in the figure
on the right) of the main unit
downwards to secure the
Ethernet adapter (C in the figure
on the right).
Caution on connection
Only one FX
3U
adapter, etc.
Connect all the high-speed I/O special adapters before connecting other special adapters when they are used
in combination.
Do not connect a high-speed I/O special adapter on the left side of any special adapters other than other
high-speed I/O special adapters.
26
→ Refer to FX
→ Refer to FX
-ENET-ADP unit can be connected in the final stage (leftmost position) of the main unit, special
(D, DS, DSS) PLC.
3UC
Hardware Edition
3U
Hardware Edition
3UC
C
4.1 FX3U-ENET-ADP Connection
PLC. For connection to
3U
→ Refer to FX
Hardware Edition
3U
→ Refer to FX
Hardware Edition
3UC
2
1
B
2
A
B
B
4
4
3
3
3
B
4 Installation