Troubleshooting; Conformance Approvals - CyberPower PDU81001 User Manual

Troubleshooting

Problem Possible Cause
PDU outlets do not 1. Breaker tripped
provide power to 2. Power cord is not
connected equipment properly plugged in
Amperage displayed
on LCD Display
exceeds the units Overload
capability
1. Sustained overload
Circuit breakers have 2. Excessive ambient or
tripped internal temperatures
3. Faulty breaker

Conformance Approvals

FCC Warning
WARNING!! This equipment has been tested and found to comply with the limits
for a Class A Digital Device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of
this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own expense.
Any special accessories needed for compliance must be specified in the
instruction.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Notice: (1) An unshielded-type power cord is required in order to meet FCC emission
limits and also to prevent interference to the nearby radio and television reception. It
is essential that only the supplied power cord by used. (2) Use only shielded cables to
connect I/O devices to this equipment.
Note: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE
CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH
MODIFICATIONS COULD VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT.
The Class A digital apparatus meets all requirements of the Canadian Interference-
Causing Equipment Regulation.
Cet appareil numerique de la class A respecte toutes les exigencies du Reglement
sur le materiel brouilleur du Canada.
16
©2016 Cyber Power Systems, Inc. All rights reserved.
Solution
Reset Breaker, check the plug to
insure its connected correctly.
If the problem remains, contact
technical support.
The load indicator shows red
when overload. Reduce the load
on the PDU until the overload
is gone. If the problem remains,
contact technical support.
Reset Breaker.
If the problem remains, contact
technical support.