Troubleshooting; Conformance Approvals - CyberPower PDU81001 User Manual

Troubleshooting

Problem
PDU outlets do
not provide power
to connected
equipment
Amperage
displayed on
LCD screen
exceeds the units
capability
Circuit breakers
have tripped

Conformance Approvals

FCC Warning
WARNING!! Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the
user's authority to operate the equipment.
WARNING!! This equipment has been tested and found to comply
with the limits for a Class A Digital Device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Notice: (1) An unshielded-type power cord is required in order
to meet FCC emission limits and also to prevent interference to
the nearby radio and television reception. It is essential that only
the supplied power cord by used. (2) Use only shielded cables to
connect I/O devices to this equipment.
Note: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY
RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED
MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS
COULD VOID THE USER'S AUTHORITY TO OPERATE THE
EQUIPMENT.
The Class A digital apparatus meets all requirements of the
Canadian Interference-Causing Equipment Regulation.
Cet appareil numerique de la class A respecte toutes les exigencies
du Reglement sur le materiel brouilleur du Canada.
European Union
This is a class A product. In a domestic environment this product
may cause radio interference in which case the user may be
required to take adequate measures.
Possible Cause
1. Breaker tripped
2. Power cord is not
properly plugged
in
Overload
1. Sustained overload
2. Excessive ambient
or internal
temperatures
3. Faulty breaker
Reset Breaker, check
the plug to insure its
connected correctly. If the
problem remains, contact
technical support.
The load indicator shows
red when overload. Reduce
the load on the PDU until
the overload is gone. If the
problem remains, contact
technical support.
Reset Breaker.
If the problem remains,
contact technical support.
28
Solution