Installation Guide
Step 2. Align and insert the Cable Tie from the bottom side of the Fixed Stand and
fasten it as shown below.
Output Power Cord
Step 1. Align and insert the Cable Tie from the upper side of the Fixed Stand and
fasten it as shown below.
Electrical Installation
Step 1. Receptacle evaluation
Ensure that the plug type of your PDU unit matches the wall receptacle
type that you are using.
The PDU must be plugged into a three-wire, grounded wall
receptacle only. The wall receptacle must also be connected to
an appropriate branch circuit/main with fuse or circuit breaker
protection. Connection to any other type of wall receptacle may
result in a shock hazard.
Step 2. Plug the PDU into the wall receptacle.
Step 3. Attach equipment
It is extremely important not to exceed the PDUs maximum current load
(as outlined in the Specifications section). In order to determine your total
load, simply use the LCD display on the front of the PDU to monitor the
load being attached.
©2016 Cyber Power Systems, Inc. All rights reserved.
11