Troubleshooting; Frequently Ask Questions (Faq); Conformance Approvals - CyberPower PDU15SW8FNET User Manual

Troubleshooting

Problem
PDU outlets do not
provide power to
connected equipment
Amperage displayed
on Metered Readout
exceeds the units
capability
Circuit breakers have
tripped

Frequently Ask Questions (FAQ)

Q. What do I do if I've lost the Administrator username and/or password?
A. Resetting the PDU will set the username and password back to system default.
Please see the Device Reset section to reset the PDU.

Conformance Approvals

WARNING!! This equipment has been tested and found to comply with the limits
fora Class A Digital Device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of
this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own expense.
Any special accessories needed for compliance must be specified in the instruction.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Notice: (1) An unshielded-type power cord is required in order to meet FCC
emission limits and also to prevent interference to the nearby radio and television
reception. It is essential that only the supplied power cord by used. (2) Use only
shielded cables to connect I/O devices to this equipment.
Note: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE
CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH
MODIFICATIONS COULD VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT.
The Class A digital apparatus meets all requirements of the Canadian Interference-
Causing Equipment Regulation.
Cet appareil numerique de la class A respecte toutes les exigencies du Reglement
sur le materiel brouilleur du Canada.
20
Possible Cause
1. Breaker tripped
2. Loose power cord
1. Overload
1. Sustained overload
2. Excessive ambient or
internal temperatures
3. Faulty breaker
For more information on CyberPower products, visit www.CPSww.com
Solution
Reset Breaker, check if plug is
completely connected. If the
problem remains, contact
tech support.
The load indicator shows red
when overload. Reduce the load
on the PDU until the overload
is gone. If the problem remains,
contact technical support.
Reset Breaker.
If the problem remains, contact
technical support.