Launch Program; Getting Started - CyberPower PDU81001 User Manual

Appendix B-Power Device Network Utility

Launch Program

To launch the Power Device Network Utility and get started, select Programs from
the Start menu in Windows and locate the new folder and icons for Power Device
Network Utility. Select Power Device Network Utility from the program folder
(Shown in Figure 3.).
Figure 3. Power Device Network Utility

Getting Started

The Power Device Network Utility scans the network for devices with MAC addresses
that match CyberPower network hardware. Once found, the device(s) can then be
figured with a specific IP address, subnet mask, and gateway address. This allows
the device(s) to function properly on the network and interface with CyberPower
Management Console.
Step 1. Select the appropriate PDU device from the Equipment List (Shown in Figure 4.).
Figure 4. Equipment List
Note: If the PDU does not appear on the list, click the Refresh button to rescan the
network. If it still does not appear, ensure that the PDU is turned on and was
installed correctly.
Pressing Stop will cancel the scan/refresh process.
Note: If your computer has a software firewall installed, you may see a Windows
Security Alert message (Shown in Figure 5.).
In Windows XP SP2, the default firewall alert message is shown as Figure 5. You
need to allow the Power Device Network Utility access through the firewall.
Figure 5. Windows Security Alert
20
©2016 Cyber Power Systems, Inc. All rights reserved.