Ethernet Port E1/E2 Status; Table 10 Ethernet Port E1/E2 Details - Honeywell 900 User Manual

Ethernet Port E1/E2 Status

Ethernet Port E1/E2 Status
The Ethernet Port E1 and Ethernet Port E2 screens both show the following details for each Ethernet port
on the controller.
Item
Port Diagnostic
Controller Name
Network Name
Local Alias
Mac Address
IP Address
Subnet Mask
Gateway IP Address
Double Register Format
Revision 9
May 2014

Table 10 Ethernet Port E1/E2 details

Shows condition of Ethernet port. See Table 11 for status details.
Configured controller name
The network name to which the controller belongs.
A locally referenced alias for the controller.
The controller's Media Access Control address.
The controller's Internet Protocol address.
The controller's subnet mask address.
The Internet Protocol address for the controller's gateway device.
Each IEEE 32-bit floating point number requires two consecutive registers (four bytes,
MSB=4, LSB=1 in byte order below) starting with the register defined as the starting
register for the information. The stuffing order of the bytes into the two registers differs
among Modbus hosts. To provide compatibility, the Double register format is
configurable. Selections are:
FPB
Floating Point Big Endian Format Byte order – 4, 3, 2, 1 (Default)
FP BB Floating Point Big Endian with byte-swapped Byte order – 3, 4, 1, 2
FP L
Floating Point Little Endian Format Byte order – 1, 2, 3, 4
FP LB Floating Point Little Endian with byte-swapped Byte order – 2, 1, 4, 3
900 Control Station User Guide
Description
Main Menu
Communications
27