Setpoint Programmer - Pre Plot Display; General Description - Honeywell 900 User Manual

Setpoint Programmers
Setpoint programmer – Pre Plot Display
Setpoint programmer – Pre Plot Display
Go to Home page > Custom Display.

General Description

This display graphically indicates a user's ramp and soak profile for a Setpoint Programmer function
block. When the associated Setpoint Programmer function block is running, Process Variable # 1 input
(PV1) of the associated function block is plotted against the pre-plot of the Setpoint Profile.
To supplement the Setpoint profile pre-plot, the display contains the following buttons and information:
• Setpoint Programmer Function Block tag Name and Description
•
Setpoint Profile recipe name and Description
• Current Segment number
• Current segment Type (Ramp/Soak)
• Segment Time Remaining
• Program Elapsed Time
• Buttons used to Run, Hold, Advance and Reset a Programmer
•
Status of the Setpoint Programmer Events (1-16)
•
Current Primary SP value
•
Current Primary PV value
•
Primary PV Engineering Units
• Current Auxiliary SP Value
• Current Auxiliary PV Value
122 900 Control Station User Guide Revision 9
May 2014