Honeywell 900 User Manual page 139

Item
Reset
PVs and SPs
PV (left)
SP (left)
PV (right)
SP (right)
PV2
PV3
Profile load/view/edit/save
Load From Profile List
Start at segment
Save To Profile Number
View/Edit Profile
Revision 9
May 2014
Reset a HOLD or STOP program to the first segment. Any edits made to
the program are lost unless they were saved. See Save To Profile
Number.
Value of primary process variable.
Value of primary setpoint.
Value of auxiliary process variable (PV4)
Value of auxiliary setpoint
Value of process variable #2
Value of process variable #3
Loads a profile from memory into the Setpoint Programmer. Program
must be in READY state.
See Figure 9 Recipe Load. You are presented with a list of profiles
(recipes) in controller memory. Scroll to the desired profile and touch to
highlight it. Touch Load Profile button to load the selected profile into the
setpoint programmer. The loaded profile overwrites the current profile
from the programmer.
To erase the currently loaded profile from the Setpoint Programmer,
select <Clear Profile> and load it. Any profile edits are lost unless you
save them first with Save To Profile Number.
After loading, the program will start at this segment. Subsequent runs will
start at Segment #1. If the segment number is within a loop, the profile
cycles through the looped segments according to the number of loop
cycles.
Saves the currently running profile (and any edits) to a selected slot in
controller memory. Scroll to the desired slot in the controller's profile
memory. Once saved, it can be loaded and run later. See Figure 10
Recipe Save.
Press to view/edit the current profile. Edits take effect immediately in the
current profile but they are not saved to profile memory. (To save your
edits, see Save To Profile Number.) When the profile is RESET, any edits
are lost unless they are first saved with Save To Profile Number. See
View/Edit profile on page 129.
900 Control Station User Guide
Setpoint Programmers
Setpoint programmer Operate
Description
127