Roland udk20 Manual page 31

B0048991 / Rev. 1.3
Method a) with the so-called sequencer mode
Advantageous when measuring is the same sheet thickness with each sensor. In contrast to the
method b) addressing of each sensor is done automatically by the UDK20. The sequence of the
sensors is predetermined in the program.
Advantage:
Disadvantage:
PLC
1. Measuring program 1
2. Analysis result of program 1
In addition to the selection by sensor number (see system configuration "number of sensors"), the
following sequences for the selection are available: Sensor 1 + Sensor 2
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Double Sheet Detector R1000 series UDK20
Very fast measurements are possible, smaller software effort on the PLC
side.
There is only 1 "summary output" for the active sensors available. For the
summary output the following priorities apply: "2-sheet prior to 0-sheet" and
"0-sheet prior to 1-sheet". (For details refer to chapter 6.2.1)
Manual
Program Thickness
1 1.5 mm
1,5 mm
System description
Sensor
1, 2
1,5 mm
31