ISSUE 6.0
8.
Connect the VOIPDB-C1 to an Switching hub using an LAN Cable.
The LAN Cable must pass two times (two rounds) through the Ferrite Core as below. (Ferrite Core
is attached with VOIPDB-C1)
VOIPDB-C1 board (CN1)
9.
Refer to the SL1100 Programming Manual for detailed programming instructions.
The VoIP feature requires system configuration.
4.2.4 LED Indication
LED indications for the IP4WW-VOIPDB-C1 are listed
page
2-72. Each LED is listed with its associated function and operational status.
Hardware Manual
< Bottom View >
Figure 2-98 Connecting a LAN Cable
< Bottom View >
Figure 2-99 Location of LEDs
LAN Cable
Ferrite Core
Pass 2 times
to HUB
Table 2-23 VOIPDB LED Indications on
VOIPDB-C1
board
LINK10
LINK100
LINK1000
ACT
SL1100
30 - 50 mm
(1.181" - 1.967")
2-71