Table of Contents
Advertisement
4.1.1 Configuration
The 2D Display can be configured by clicking the
Doc. P/N:
WSP-009-008
Version:
V1.3
Issue Date:
April 2014
l
This menu contains the settings that influence how the bottom
ayers
data is drawn
l
/c
iGhtinG
OlOur
c
OlOur
The Colour Tab shown allows you to set the depth limits over
which the colour range will apply when viewing seafloor data.
The maximum colour depth is set to 800m by default. This can
be modified under "Cartography" on the Chart tab (see page
52).
There are two angled arrow buttons (
The top one sets the Red colour depth.
►
The bottom one sets the Blue colour depth.
►
Both buttons can be clicked on with the left mouse button and
then dragged up/down.
When the mouse button is released, the colours will change on
the main window.
The other four up/down arrow buttons can be used to fine-tune
the colour range.
Colours only effect the display of seafloor data if in Colour
Depth mode.
The Auto Colour check box will automatically assign a colour
range, centred around the current depth.
While Auto Colour is enabled, it is not possible to manually
change the upper or lower colour settings. Instead, the range
value can be modified using the up/down arrows beneath the
Auto Colour check box.
in the top left corner of the display window.
t
aB
www.wassp.com
Operator Manual
C ha rt Di s pla y Mo des
,
):
19
Advertisement
Table of Contents
