Table of Contents
Advertisement
3.2
Single / Triple Beam Display
The Single / Triple Beam Display shows seafloor and water column information in a similar fashion
to the traditional fish-finder display. Signal returns are drawn vertically in slices, with new information
appearing on the right of the display, and old information dropping off the left side.
In Single Beam mode, only the middle beam is used to draw the information from the seafloor.
In Triple Beam mode, additional port and starboard beams are used to draw information from selectable
areas of the water column through configuration of the beam width and beam angle. See Figure 5.
Single Beam (Middle Beam)
3.2.1 Configuration
The Single / Triple Beam Display can be configured by clicking the
display window.
Doc. P/N:
WSP-009-008
Version:
V1.3
Issue Date:
April 2014
Port Beam
Middle Beam
Starboard Beam
Triple Beam (Horizontal)
Figure 5.
Single / Triple Beam Display Layouts
O
This button opens up the Options for the Single / Triple Beam
ptiOns
Display.
G
Overlays a grid on top of the Single / Triple Beam display, to enable
rid
the user to quickly judge distances to targets.
Grid size selectable from 5 depth units to 100 depth units.
B
a
This adjusts the angle which the centres of the port and starboard
eam
nGle
beams are set from the middle beam. Larger angles move
the beams further from the middle beam, and smaller angles
move the port and starboard beams closer to the middle beam.
The beam angle can be set to 5, 10, 15, 20, 30, or 40°.
B
W
This adjusts the width of the three individual beams used for the
eam
idth
Single / Triple Beam Display, and can be set to 5, 10, 15, 20, 30,
or 40° widths. Selecting a 10° beam width with a 20° triple beam
angle will therefore give a 50° swath for the Triple Beam view. See
Figure 6.
www.wassp.com
Operator Manual
Ac ou s tic Dis pla y Mod es
Port
Middle
Starboard
Beam
Beam
Beam
Triple Beam (Vertical)
in the top left corner of the
11
Advertisement
Table of Contents
