Table of Contents
Advertisement
Open the Raw Info display from the Utility Panel,
6
then the Sensor Data tab.
Confirm that the Roll, Pitch, Heave and Heading
readings are all active and correct.
Click the MODE button to start pinging.
7
Confirm that the icon animates while pinging,
showing a pulse moving down from the vessel.
Switch to the Sonar display.
8
The Range Control might have locked on to an
9
incorrect depth. Adjust the Range Control dial so
that the returned signal from the seafloor can be
seen on the Sonar display.
Double-click on the range indicator to switch
between automatic range and manual range.
On the Main Menu, set the Power Level to
10
Automatic.
Double-click on the power level indicator to
switch between automatic power and manual
power.
Cycle through each of the layouts for both the
11
Acoustic and Charting views, and confirm that they
all display and draw correctly.
68
www.wassp.com
Doc. P/N:
WSP-009-008
Version:
Issue Date:
April 2014
V1.3
Advertisement
Table of Contents
