Table of Contents
Advertisement
5·13 CHASSIS
MASTER CYLINDER REASSEMBLY AND
REMOUNTING
Reassemble the master cylinder in the reverse order of
removal and disassembly. Pay attention to the following
points:
! ACAUTION!
*
Wash the master cylinder components with fresh
brake fluid before reassembly. Never use cleaning sol-
vent or gasoline to wash them.
*
Do not wipe the components with a rag.
*
Apply brake fluid to the cylinder bore and all the com-
ponent to be inserted into the bore.
~
Specification and classification: DOT 4
• When remounting the master cylinder on the handlebars,
align the master cylinder holder's lower mating surface
CD
with punched mark
0
on the handlebars and tighten
the upper clamp bolt first as shown.
~
Master cylinder mounting bolt:
10 N·m (1.0 kg-m, 7.0 Ib-ft)
! ACAUTION!
Bleed air from the system after reassembling master
cylinder. (Refer to page 2-11.)
Upper
clamp
bolt
"UP" mark
--H-
Clearance
Advertisement
Table of Contents
