Table of Contents
Advertisement
6·1
ELECTRICAL SYSTEM
CAUTIONS IN SERVICING
CONNECTOR
• When connecting a connector, be sure to push it in untill
a click is felt.
• Inspect the connector for corrosion, contamination and
breakage in its cover.
COUPLER
• With a lock type coupler, be sure to release the lock be-
fore disconnecting it and push it in fully till the lock works
when connecting it.
• When disconnecting the coupler, be sure to hold the cou-
pler itself and do not pull the lead wires.
• Inspect each terminal on the coupler for being loose or
bent.
• Inspect each terminal for corrosion and contamination.
CLAMP
• Clamp the wire harness at such positions as indicated in
"WIRE HARNESS ROUTING" (Refer to pages 7-12 and
13.).
• Bend the clamp properly so that the wire harness is
clamped securely.
• In clamping the wire harness, use care not to allow it to
hang down.
• Do not use wire or any other substitute for the band type
clamp.
FUSE
• When a fuse blows, always investigate the cause, cor-
rect it and then replace the fuse.
• Do not use a fuse of a different capacity.
• Do not use wire or any other substitute for the fuse.
SEMI-CONDUCTOR EQUIPPED PART
• Be careful not to drop the part with a semi-conductor built
in such as a CDI unit and regulator/rectifier.
• When inspecting these parts, follow inspection instruc-
tion strictly. Neglecting proper procedure may cause
damage to these parts.
CORRECT
INCORRECT
Advertisement
Table of Contents
