Table of Contents
Advertisement
3·11 ENGINE
• Remove the cylinder by removing the nuts.
I
A
CAUTION
I
If tapping with a plastic hammer is necessary, do not
break the fins.
• Place a clean rag over the cylinder base to prevent the
piston pin circlips from dropping into crankcase. Remove
the piston pin circlips with a long-nose pliers.
• Remove the piston by removing the piston pin.
• Remove the clutch cable holder and starter motor.
• Remove the starter torque limiter
CD
and starter idle gear
@
with shaft.
• Loosen the generator rotor bolt with the 36 mm offset
wrench.
NOTE:
Do not remove the generator rotor bolt after loosening the
bolt. The generator rotor bolt is used in conjunction with
the rotor remover, when removing the generator rotor.
Advertisement
Table of Contents
