Table of Contents
Advertisement
6·11 ELECTRICAL SYSTEM
TROUBLESHOOTING
Starter motor
will
not run.
The transmission is in neutral.
Turn on the ignition switch with
the engine stop switch in "RUN"
position.
Check whether to hear the click
noise from the starter relay when
the starter button is pushed.
No click
Measure the starter relay voltage
at the starter relay connectors
(between Y /G
8)
and B/W
8)
when the starter button is pushed.
I
Voltage measured
1
Check the starter relay.
(Refer to page 6-14.)
I
Correct
f - - - - -
Clicks
----:J~
Check whether to run the
starter motor when connect the
starter motor terminal to the
battery
8)
terminal directly.
(Do not use thin wire, because
a large amount of current
flows.)
I
I
Run
Not run
1
~
• Faulty starter motor
• Faulty starter relay
• Loosen or disconnected starter
motor lead wire
-
Not
voltage---:J.~.
Faulty ignition switch
• Faulty engine stop switch
• Faulty neutral switch
• Faulty diode
• Faulty side-stand relay
• Faulty starter button
• Faulty clutch lever position switch
• Poor contact of connector
• Open circuit in wiring harness
I--Incorrect----l.~·
Faulty starter relay
[I-----------------~
• •
Poor contact of the starter relay
Starter motor runs when the transmission is in neutral, but does not run with the transmission in
any position except neutral, with the side-stand up position.
Check the side-stand switch.
(Refer to page 6-16.)
I
Correct
I--Incorrect------J.~·
Faulty side-stand switch
L [
----------------~
• •
Open circuit in wiring harness
• Poor contact of connector
(
Others)
Engine does not turn
though starter motor runs.
• Faulty starter clutch
Advertisement
Table of Contents
