Table of Contents
Advertisement
PNA Series Microwave Network Analyzers
N5242A
Section Title
Preliminary Checks
System Verification
a
Performance Tests
b
Adjustments
a. These performance tests are included in the analyzer's firmware for Options 897 and
898.
b. These adjustments are included in the analyzer's firmware on all models and options.
Service Guide N5242-90001
Summary of Content
Performing the operator's check.
Checking your test cables.
Perform these checks before performing system
verification.
What the system verification does.
How to perform the verification test.
How to interpret the results.
A brief summary of each performance test:
•
Source Maximum Power Output Test
•
Source Power Linearity Test
•
Frequency Accuracy Test
•
Trace Noise Test
•
Receiver Compression Test
•
Noise Floor Test
•
Calibration Coefficients Test
•
Dynamic Accuracy Test
Setups and procedures for adjusting your analyzer:
•
10 MHz Frequency Reference Adjustment
•
IF Gain Adjustment
•
Synthesizer Bandwidth Adjustment
•
Source Adjustment
•
Receiver Adjustment
•
Receiver Characterization
•
EE Default Adjustment
Tests and Adjustments
Information in This Chapter
Start Page
Page 3-10
Page 3-19
Page 3-28
Page 3-35
3-3
- Quick Links:
- Source Power Accuracy Test
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
