Power Up Troubleshooting - Agilent Technologies N5242A Service Manual

Troubleshooting

Power Up Troubleshooting

Power Up Troubleshooting
Immediately unplug the instrument from the ac power line if the
WARNING
unit shows any of the following symptoms:
• Smoke, arcing, or unusual noise from inside the analyzer.
• A circuit breaker or fuse on the main ac power line opens.
Check your network analyzer for evidence that it is powering up correctly. Perform the
following steps and make sure that the analyzer is displaying correct behavior as noted in
the following steps.
Step 1. Disconnect all peripherals and plug in the network analyzer. Before the analyzer
is powered on, the line switch should glow yellow and no other lights should be
on.
Step 2. Turn on the network analyzer.
• The line switch should glow green.
• The fans should be audible.
• The display should flash and then show the hardware boot-up sequence. This
process checks the RAM and communication with the hard disk drive. These
checks return an error message if a problem is detected.
• The Windows operating system should start.
• The network analyzer measurement interface should open with an S
measurement displayed.
Step 3. If the analyzer powers up correctly, continue troubleshooting with
Troubleshooting" on page
Step 4. If the analyzer does not power up correctly, follow these troubleshooting steps:
• If the line switch does not glow, go to
• If you cannot hear the fans operating, go to
page 4-11.
• If the line switch glows green and the fans are operating (audible), but the
display remains dark, go to
page 4-12.
• If the instrument appears to abort the network analyzer measurement
interface process, contact Agilent. Refer to
4-6
4-13.
"Power Supply Check" on page
"If the Fans Are Not Operating" on
"Troubleshooting LCD Display Problems" on
"Contacting Agilent" on page
PNA Series Microwave Network Analyzers
"Front Panel
Service Guide N5242-90001
N5242A
11
4-7.
2-13.