Agilent Technologies N5242A Service Manual page 30

General Product Information
Required Service Test Equipment
Required Service Test Equipment (Cont'd)
a
Equipment
T-8 TORX driver
T-10 TORX driver
T-15 TORX driver
T-20 TORX driver
1/4 inch and 5/16 inch open-end
wrench
5/16 inch, open-end torque wrench
(metric equivalent is 8 mm)
1 inch, open-end torque wrench
(metric equivalent is 26 mm)
20 mm, open-end torque wrench
Adjustable antistatic wrist strap
Antistatic wrist strap grounding
cord (5 foot)
Static control table mat and earth
ground wire
USB flash ROM drive
a. Unless specified otherwise, equipment listed is required for all analyzer models.
b. P = Performance tests, A = Adjustments, T = Troubleshooting, R = Repair, V = System verification
2-12
Critical Specifications
Tools
0.6 N-m (5 in-lb) setting
0.5, 0.8, and 1.0 N-m
(4, 7, and 9 in-lb) settings
1.5 N-m (14 in-lb) setting
2.4 N-m (21 in-lb) setting
Thin profile
1.1 and 2.4 N-m (10 and 21
in-lb) settings (for semi-rigid
cables)
8.1 N-m (72 in-lb) setting (for
Port 1 and Port 2 connector
nuts)
0.9 N-m (8 in-lb) setting (for
measurement port
connections)
Static Safety Parts
N/A
N/A
N/A
Miscellaneous
N/A
PNA Series Microwave Network Analyzers
Recommended Alternate
Model or Part Model
Number Number
N/A N/A
N/A N/A
N/A N/A
N/A N/A
8710-0510 N/A
N/A
N/A
N/A N/A
N/A
8710-1764
9300-1367 None
9300-0980 None
9300-0797 None
Any None
Service Guide N5242-90001
N5242A
b
Use
R
T, R
T, R
T, R
A, R
T, R
R
P, A, T
P, A, T
P, A, T
P, A, T
P, A