Table of Contents
Advertisement
Figure 147. System battery
If you are replacing a server component in the server, you need to turn off the server and peripheral devices,
and disconnect the power cords and all external cables.
To remove the battery, complete the following steps.
Step 1.
Carefully turn the server on its side so that it is lying flat, with the cover facing up.
Attention: Do not allow the server to fall over.
Step 2.
Unlock and remove the left-side cover (see "Removing the left-side cover" on page 184).
Step 3.
Remove the system battery:
a.
If there is a rubber cover on the battery holder, use your fingers to lift the battery cover from
the battery connector.
b.
Use one finger to tilt the battery horizontally out of its socket, pushing it away from the socket.
Attention: Neither tilt nor push the battery by using excessive force.
c.
Use your thumb and index finger to lift the battery from the socket.
234
System x3500 M4 Installation and Service Guide
Battery
Advertisement
Table of Contents
Troubleshooting
