Lenovo System x3500 M4 Installation And Service Manual page 219

To install a 3.5-inch simple-swap hard disk drive, complete the following steps.
Step 1. Unlock the left-side cover.
Note: You must unlock the left-side cover to open or remove the bezel. When you lock the left-side
cover, it locks both the cover and the bezel.
Step 2. Open the bezel (see "Opening the bezel media door" on page 181).
Step 3. Remove the filler panel, if one is present.
Step 4. Touch the static-protective package that contains the disk drive to any unpainted metal surface on
the server; then, remove the disk drive from the package and place it on a static-protective surface.
Step 5. Grasp the black drive handle and slide the blue release latch to the right and align the drive
assembly with the guide rails in the bay.
3.5-inch
simple-swap
hard disk drive
Figure 119. Simple-swap hard disk drive installation
Step 6. Gently push the drive into the bay until the drive stops.
Step 7. Close the bezel (see "Closing the bezel media door" on page 183).
Step 8. Lock the left-side cover.
If you have replaced a server component or installed an optional device in the server, you need to reconnect
the power cords and all external cables, and turn on the server and peripheral devices.
Removing a DVD drive
Use this information to remove a DVD drive.
Read the safety information in "Safety" on page v and "Installation guidelines" on page 35.
If you are replacing a server component in the server, you need to turn off the server and peripheral devices,
and disconnect the power cords and all external cables.
To remove the DVD drive, complete the following steps.
Step 1. Unlock and remove the left-side cover (see "Removing the left-side cover" on page 184).
Step 2. Open the bezel (see "Opening the bezel media door" on page 181).
Filler panel
Drive handle
Release latch
.
Chapter 6 Removing and replacing components
205