Part No. 920525 Rev A - Wayne 3/VISTA series Service Manual

1 = ON at end of display test
2 = ON at start of display test
3 = ON at product selection
.01 Lock on filling mode configuration
1 = Access to filling mode configuration restricted
2 = Access allowed.
.02 Standalone indication enabled (show four digits right of decimal point)
1 = Yes
2 = No
.03 Blank or dash unselected unit price displays on product selection
1 = Blank
2 = Dash
.04 Product change allowed after fuelling started
1 = product change allowed after fuelling started
2 = product change not allowed after fuelling started
.05 Electro-mechanical totalizer configuration
1 = Each side has it's own electro-mechanical totalizers per meter
2 = One electro-mechanical totalizer per meter shared by both sides
.06 Dianostic Flow Rate Display, 1 = Display Sale Amount, 2 = Display Flow Rate
F22 - Sales Amount Calculation
Sub-function numbers are in the format .0X where X = the selected configuration parameters defined as follows:
.00 Denomination ratio between Money display and Unit Price display
1 = 1/1
2 = 10/1
3 = 100/1
4 = 1/10
5 = 1/100
.01 Count by ones or fives in least significant digit of Money display
1 = Ones
2 = Fives
.02 Volume digits to the right of the decimal point used in amount calculation 0-5, where 5 = use volume
decimal point as defined in function 18.5
.03 Money preset configuration. As the unit price increases, the system reaches a point when certain preset
money amounts cannot be set due to the resolution of the metering system and/or the configured resolution
of the volume used for the money calculation. Program this sub-function to give the desired result when this
occurs.
0 = Calculate the closest volume from the money and the unit price and show the actual money amount at the
end of the sale.
June 2001
49

Part No. 920525 Rev A