Part No. 920525 Rev A - Wayne 3/VISTA series Service Manual

F01 - Filling Modes
Sub-function numbers are in the format .0X where X = the selected configuration parameters defined as follows:
.00 Filling Mode, 1 through 4
1 = Serial Mode, dispenser controlled by site controller via serial link
2 = Stand Alone Mode, dispenser not supervised by a site controller
3 = Serial W&M Mode, same as #1 but volume decimal point format forced to .xxx volume units
4 = Stand Alone W&M Mode, same as #2 but volume decimal point format forced to .xxx units
F02 - Clock Configuration
Sub-function numbers are in the format .0X where X = the selected configuration parameters defined as follows:
.00 Time in the format HH.MM
.01 Date in the format MM.DD
.02 Year in the format YY.YY
Note:
System does not update automatically for Daylight Savings Time.
F03 - Set Side A Unit Prices
Note:
These functions are not part of the template data.
Sub-function numbers are in the format:
.0N Set credit prices
.1N Set cash prices
N Logical nozzle number 1-8
F04 - Set Side B Unit Prices
Note:
These functions are not part of the template data.
Sub-function numbers are in the format:
.0N Set credit prices
.1N Set cash prices
N Logical nozzle number 1-8
F05 - Set Side A Fueling Point Address
.00 Fueling Point Address, 0 through 98, where 0 = None Assigned
F06- Set Side B Fueling Point Address
.00 Fueling Point Address, 0 through 98, where 0 = None Assigned
F07 - Dispenser Configuration
Sub-function numbers are in the format .0X where X = the selected configuration parameters defined as follows:
.00 Maximum logical nozzle number for each side, 1-8
.01 Dispenser geometry, 1 = single sided, 2 = double sided
.02 Maximum blend error allowed, 1-5 (units of %)
.03 First check set for blending if liters, 2-200 (units of 1/10 Liters)
.04 First check set for blending if gallons, 5-50 (units of 1/10 Gallons)
.05 Not Used
44

Part No. 920525 Rev A

June 2001