Part No. 920525 Rev A - Wayne 3/VISTA series Service Manual

.08 Maximum volume amount/filling, 1-6 digits
F18 - Blend Ratio Configuration
Sub-function numbers are in the format: SN where S = the Side number (1=A, 2=B) and N = the logical nozzle
number 1-8.
SN. Blend ratio (the allowed range for data is 0-101, where 101 = Disabled for a non-blend 000 is
F19 - Volume Unit Specific Configuration
Sub-function numbers in the format .VX where V= volume unit selection (1= liters, 2=gallons) and X = the selected
configuration parameters defined a follows.
.10 Suppressed volume @ start of filling, 1-9 cl.
.11 Maximum volume for selection of new product, 1-9 cl.
.12 Suppress overflow of preset limit, 0-99 cl.
.13 Preset/Prepay slow down volume delta. 5-399 cl.
.14 Forward pulse limit on idle/unused WIP. 1-99 cl.
.20 Suppressed volume @ start of filling, 1-99 (units of 1/1000 Gallons)
.21 Maximum volume for selection of new product, 1-99 (units of 1/1000 Gallons)
.22 Suppress overflow of preset limit, 0-99 (units of 1/1000 Gallons)
.23 Preset/Prepay slow down volume delta. 2-999 (units of 1/1000 Gallons)
.24 Forward pulse limit on idle/unused WIP. 1-999 (units of 1/1000 Gallons)
F20 - Dispenser Serial Link Configuration
Sub-function numbers are in the format .0X where X = the selected configuration parameters defined as follows:
.00 Protocol
0 = Off link
1 = RS485 Standard DART
2 = RS485 Full DART
3 = LON
4 = U.S. Current Loop
5 = Ljungman Current Loop
6 = Ferranti
Note:
"4 = US current loop" is the only protocol currently supported.
.01 Baud rate
1 = 4800
2 = 9600
3 = 19200
4 = 38400
.02 CRC Calculation. 1 = Enable, 2 = Disable
.03 Send "Filling Complete" after zero sale. 1 = Yes, 2 = No
.04 Serial Link Control of the Dispenser Light Enable. 1 = Yes, 2 = No
F21 - Miscellaneous Configuration
Sub-function numbers are in the format .0X where X = the selected configuration parameters defined as follows:
.00 Pump Motor ON configuration
48

Part No. 920525 Rev A

June 2001