Quad Gigabit Ethernet Line Card (Qglc) - Cisco ASR 5000 Installation Manual

Cabling the Gigabit Ethernet Line Cards
Module
Type
1000Base-LX
1000Base-T
Important
Important

Quad Gigabit Ethernet Line Card (QGLC)

The following figure shows the four-port Quad Gigabit Ethernet Line Card (QGLC). The front panel of this
card is labeled "Ethernet 1000".
Card Interface
Identification Type
Ethernet Fiber, LC
1000 LX duplex
female
connector
Ethernet RJ-45
1000
Copper
The SFP interface is only certified to work with SFP transceiver modules purchased from Cisco for use
with the GLC2.
Class 1 Laser Compliance Notice
Because of the optical SFP interface, this product has been tested and found to comply with the limits for
Class 1 laser devices for IEC825, EN60825, and 21CFR1040 specifications.
Quad Gigabit Ethernet Line Card (QGLC)
Cable Specifications
Fiber Type: Single-mode fiber (SMF), 1310 nm wavelength
Core Size (microns)/Range: 9/32808.4 feet (10 Kilometers)
Minimum Tx Power: -9.5 dBm
Rx Sensitivity: -19 dBm
Operates in full-duplex up to 100 meters of CAT-5 shielded
twisted pair (STP) cable with BER less than 10e-10.
NOTE: To comply with GR-1089 intra-building,
lightning-immunity requirements and ensure compliance with
Radiated Emissions Criteria, you must use shielded-twisted pair
cable and ensure that it is properly terminated at both ends.
ASR 5000 Installation Guide
109