Installing Pc Cards - Cisco ASR 5000 Installation Manual

Installing PC Cards

Installing PC Cards
This section provides instructions for installing a PC Card in the SMC.
If you are performing an initial installation of a PC Card, begin with step 1. If you are replacing a PC Card
that you have removed according to the procedures in
Caution During installation, maintenance, and/or removal, wear a grounding wrist strap to avoid ESD damage to
the components. Failure to do so could result in damage to sensitive electronic components and potentially
void your warranty
Step 1
Identify the slot where you are installing the PC Card.
Step 2 Use a Phillips #1 screwdriver to remove the two screws securing the PC Card slot cover.
Step 3 Remove the PC Card slot cover.
Step 4
Align the PC Card with the slot's upper and lower card guides and slide the card into the slot until it can go no further.
The face/top of the PC Card, typically where the manufacturer's brand name information is located on the label, should
be facing to the right side of the card.
Step 5
Align the PC Card slot cover over the open slot.
ASR 5000 Installation Guide
186
Removing and Installing SMC PC Cards
Removing PC Cards, on page 187, begin with step 4.