Chapter - Cisco ASR 5000 Installation Manual

Cabling the Channelized Line Cards
This chapter provides information about the physical interfaces and instructions for installing the cables on
the CLC2 (STM-1/OC-3).
This chapter includes the following sections:
•
•
Channelized Line Card Interfaces
The CLC2 card supports two types of Small Form-factor Pluggable (SFP) transceiver modules. The type of
optical fiber interface on the line card is dictated by the SFP modules installed on the card. The SFP modules
are hot-pluggable.
Table 45: SFP Modules Supported by the CLC2
Module Type
Single-mode
Optical Fiber
Channelized Line Card Interfaces, page 121
Cabling the Optical SFP Interface, page 123
Card Interface
Identification Type
Channelized Single-mode
(STM-1/OC-3) Fiber, LC
SM IR-1 duplex
female
connector
C H A P T E R
Cable Specifications
Fiber Types: Single-mode optical fiber
Wavelength: 1310 nm
Core Size: 9 micrometers
Cladding Diameter: 125 micrometers
Range: Intermediate/21 kilometers
Attenuation: 0.25 dB/KM
Min/Max Tx Power: -15 dBm/-8 dBm
Rx Sensitivity: -28 dBm
ASR 5000 Installation Guide
10
121