Installing The Application Card - Cisco ASR 5000 Installation Manual
Hide thumbs
Also See for ASR 5000:
- Administration manual (466 pages) ,
- Installation manual (37 pages) ,
- Installation procedure (8 pages)
Table of Contents
Advertisement
Replacing Application Cards
Important
If the card just removed from the chassis was an SMC, proceed to
on page
Installing the Application Card
This section describes how to install an application card.
Step 1
Slide the interlock switch on the card fully downward. Flip the ejector levers outward and away from the card's faceplate.
Step 2
Holding the card by its ejector levers, align the card with the upper and lower card guides of the appropriate chassis slot
and gently slide the card into the slot until the levers touch the chassis frame.
Caution
Take extra caution when installing packet processing cards. These cards contain heat sinks that could become
loose or damaged if they come into contact with an adjacent card while the packet processing card is being
inserted in the chassis slot.
220.
Installing the Application Card
Replacing the CompactFlash on an SMC,
ASR 5000 Installation Guide
217
Advertisement
Table of Contents
