Adding Half-Height Line Cards
Step 6
Push the ejector levers inward firmly until the card is firmly seated in the chassis midplane and the ejector levers can be
pushed in no further. Press firmly on the card's faceplate to ensure that it is fully seated. The card's front panel should
be flush against the chassis' upper and lower card mounts for the slot.
Step 7
Slide the interlock switch on the front panel of the line card upward to lock the ejector tab in place. The flange on the
left-side of the interlock switch prevents movement of the ejector tab when raised completely.
Step 8
Use a Phillips #2 screwdriver to tighten the screws at the top and bottom of the line card's front panel to secure the card
to the chassis.
Step 9
Repeat step 1 through step 7 for every other line card that to be installed.
Step 10
Install blanking panels over any unused chassis slots.
ASR 5000 Installation Guide
180
Adding Application and Line Cards to an Existing Installation