Asr 5000 Installation Guide - Cisco ASR 5000 Installation Manual

Adding Application and Line Cards to an Existing Installation
Step 4 Push the ejector levers inward firmly until the card is firmly seated in the chassis midplane and the ejector levers can be
pushed in no further. Press firmly on the card's faceplate to ensure that it is fully seated. The card's front panel should
be flush against the chassis' upper and lower card mounts for the slot.
Step 5
Slide the interlock switch on the front panel of the line card upward to lock the ejector tab in place. The flange on the
left-side of the interlock switch prevents movement of the ejector tab when raised completely.
Important You must slide the interlock switch upward before securing the card's top screw to the mounting
rail.
Installing the XGLC

ASR 5000 Installation Guide

183