Channelized Line Card (Clc2) - Cisco ASR 5000 Installation Manual

Channelized Line Card (CLC2)

Install the OLC2 directly behind its respective (active) packet processing card. As with other line cards, install
the Optical (ATM) Line Card in slots 17 through 23, 26 through 39, and 42 through 48.The following figures
show the panel of the OLC2, indicating its ports and major components.
Figure 18: Optical Line Card (OLC2)
Table 19: OLC2 (ATM) Callouts
Item
1
2
3
4
5
6
Channelized Line Card (CLC2)
The CLC2 is also referred to as the Frame Relay line card. It provides frame relay over SONET or SDH. The
CLC2 supports network connectivity through a gigabit interface to connect to the Packet Control Unit (PCU)
ASR 5000 Installation Guide
34
Description
Card Ejector Levers—Use to insert/remove card to/from chassis.
Interlock Switch—In its Down position, the interlock switch notifies the system to safely power
down the card prior to its removal.
Card Level Status LEDs—Show the status of the card.
Port connectors—Fiber LC duplex female connector.
Port Level Status LEDs—Show the status of a port.
Line Card Label—Identifies the type of SFP modules and cabling supported:
• OLC2, OC-3/STM-1, Single Mode
• OLC2, OC-3/STM-1, Multi-Mode
ASR 5000 Hardware Platform Overview