Connecting To The Management Lan - Cisco ASR 5000 Installation Manual

Connecting to the Management LAN

Item
3
4
5
6
7
Connecting to the Management LAN
The SPIO provides two types of interfaces for physical connection to the management LAN: the fiber optic
SFP and the Ethernet (RJ-45) interfaces.
When you cable these interfaces, make sure you do only one of the following:
• Both SFP interfaces
• Both Ethernet interfaces
• SFP 1 and Ethernet 2
• SFP 2 and Ethernet 1
Important
Using the SFP Interfaces
The two optical 1000Base-SX SFP interfaces are hot-pluggable 802.3z-compliant Gigabit Ethernet interfaces
that take their configuration from the inserted cable type. Refer to the following table for information about
supported cable specifications.
ASR 5000 Installation Guide
88
Label Connector Type
Ethernet 1 RJ-45
Ethernet 2 RJ-45
Console RJ-45
BITS 3-Pin 3-pin Wire Wrap
CO Alarms 10-pin Molex
Be sure to label the interface cables with their destination prior to connecting them to the SPIO. This will
assure proper reconnection should the card need to be serviced.
Cabling the Switch Processor Input/Output Line Card
Description
10/100/1000 Ethernet for connecting to management
LAN
10/100/1000 Ethernet for connecting to management
LAN
RS-232 interface for local administration of the
system
BITS interface for T1 (DS1) clock source [software
selectable]
NOTE: This interface is not used for systems
supporting data applications.
®
Isolated dry-contact relay interfaces for connection
to Central Office (CO) alarm monitoring panel