Application Set-Up Examples; Introduction; Application Examples - GE AF-650 GP Design And Installation Manual

Application Set-Up Examples

6 Application Set-Up Examples

6.1 Introduction

The examples in this section are intended as a quick
reference for common applications.
•
Parameter settings are the regional default values
unless otherwise indicated (selected in
parameter K-03 Regional Settings).
•
Parameters associated with the terminals and
their settings are shown next to the drawings.
•
Where switch settings for analog terminals A53 or
A54 are required, these are also shown.
•
For STO, a jumper wire may be required between
6 6
terminal 12 and terminal 37 when using factory
default programming values.

6.2 Application Examples

Table 6.1 Analog Speed Reference (Voltage)
48
Parameters
Function Setting
Parameter AN-10
Terminal 53 Low
Voltage 0.07 V*
Parameter AN-11 10 V*
Terminal 53 High
Voltage
Parameter AN-14 0 RPM
Terminal 53 Low
Ref./Feedb. Value
Parameter AN-15 1500 RPM
Terminal 53 High
Ref./Feedb. Value
* = Default Value
Notes/comments:
DET-767c All rights reserved.
Parameter AN-12
Terminal 53 Low
Current
Parameter AN-13
Terminal 53 High
Current
Parameter AN-14
Terminal 53 Low
Ref./Feedb. Value
Parameter AN-15
Terminal 53 High
Ref./Feedb. Value
* = Default Value
Notes/comments:
Table 6.2 Analog Speed Reference (Current)
Parameter E-01 T
erminal 18
Digital Input
Parameter E-07 T
erminal 37 Safe
Stop
* = Default Value
Notes/comments:
Table 6.3 Start/Stop Command with Safe Torque Off
Parameters
Function Setting
4 mA*
20 mA*
0 RPM
1500 RPM
Parameters
Function Setting
[8] Start*
[1] Safe Stop
Alarm
MG35M402