Programming; How To Programme; Programming With Dct-10 Set-Up Software; Programming With The Keypad - GE AF-60 LP Programming Manual

3. Programming

3.1. How to Programme

3.1.1. Programming with DCT-10 Set-up Software

The frequency converter can be programmed from a PC via RS485 com-port by installing the DCT-10 Set-up Software.
This software can be downloaded from the GE Web site: www.geelectrical.com/drives

3.1.2. Programming with the Keypad

The Keypad is divided into four functional groups:
1. Numeric display.
2. Menu key.
3. Navigation keys.
4. Operation keys and indicator lights (LEDs).
NB!
Parameters should be changed in numerical order. Certain parameter values are affected by preceding changes.
Illustration 3.1: Keypad with potentiometer
The display:
A number of information can be read from the display.
Set-up number shows the active set-up and the edit set-up. If the same set-
up acts as both active and edit set-up, only that set-up number is shown
(factory setting).
When active and edit set-up differ, both numbers are shown in the display
(Setup 12). The number flashing, indicates the edit set-up.
AF-60 LP™ Micro Drive Programming Guide
Illustration 3.3: Indicating Set-up
3
7