DENT Instruments ELITEpro XC Operator's Manual page 68

Retrieve Data From Logger
Retrieves data from the logger and saves it as an .elog file on the hard disk. The Select A Directory And A
Name... dialog box displays prompting you for a file name. The default name is the logger serial number
plus two digits that correspond to the number of times that data has been retrieved from the logger,
however, at this point you may name the data file whatever you wish.
There are two checkboxes in the lower left of the dialog box to select if you want to add (append) the
data to an existing file and/or create an ASCII file of the data.
When a logger's memory is downloaded, the data may be added or "appended" to an already existing
file from the same logger. Check the Append New Data To Existing Data File box. The name of the
dialog box changes to Select a Data File to Append Data To and select which file you wish to add the
data to.
The chosen file must have the same Setup Table used when the earlier data was downloaded. Selecting
a file with different Setup Table parameters than those in the logger to be downloaded causes the
following warning to display:
68
PowerMeterStore
1.877.766.5412
www. .com
Shop for Dent products online at: