Instruction Manual
IM-106-350, Rev 2.2
July 2008
Section 4
VERIFY INSTALLATION
Mechanical Installation
Terminal Block Wiring
http://www.raihome.com
Configuration of Oxymitter 5000
with LOI
Verify installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 4-1
Logic I/O . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 4-4
Install all protective equipment covers and safety ground leads before equipment startup.
Failure to install covers and ground leads could result in serious injury or death.
NOTE
Refer to Appendices C, D, and E for fieldbus information concerning the
Hazardous Area Oxymitter 5000.
Ensure the Oxymitter 5000 is installed correctly. See Section 2: Installation.
1. Remove cover (31) to expose terminal block (29).
2. Check the terminal block wiring, Figure 4-1. Be sure the power, fieldbus
digital signal, and logic outputs are properly connected and secure. To
avoid a shock hazard, the power terminal cover must be installed. For
units with remote electronics, check the terminal block wiring at the
probe and at the remote electronics unit.
3. Install housing cover (31, Figure 9-3 or Figure 9-4) on terminal block
(29).
Oxymitter 5000