Static Color Mode; Settings; Reset Factory Settings - SHOWTEC V1 User Manual

LED Lightbar 12 Pixel

Static Color Mode

With this menu you can create a static color.
01) Press the Mode button, until the display shows
02) Press the Setup button to make a color.
03) With this sub menu you can set 4 static colors of the LED Lightbar 12 Pixel.
You can choose Red, Green, Blue or White by pressing the Setup button.
Use the Up / Down buttons to set the values of each individual color from 000-255.

Settings

With this menu you can set the DMX fail of the LED Lightbar 12 Pixel and you can see the temperature.
01) Press the Mode button, until the display shows
02) Use the Setup button to choose
03) Press the Setup button again and use the Up and Down buttons to choose between
and mode.
01) When you choose
out if there is no DMX signal.
04) When you choose
05) Press the Setup button again and the display will show
06) Press Setup again and you can see the actual temperature
07) If the temperature is too high, the display will show

Reset factory settings

Switch the power off and hold at the same time the Mode and Up button.
Switch the power on for 5 seconds and release the Mode and Up button.
The LED Lightbar 12 Pixel will reset to the factory settings. The fixture will start up in the Auto Run mode.
Ordercode: 42197
.
, the LED Lightbar 12 Pixel will remember the last settings and will not go
, the LED Lightbar 12 Pixel will go out if there is no DMX signal.
16
.
.
.
.
.
mode