Overview; Installation; Set Up And Operation; Control Modes - SHOWTEC V1 User Manual

LED Lightbar 12 Pixel

Overview

01) IEC Power In
02) Ground/Earth connection
03) Fuse T1L / 250V
04) 12 x 4W RGBW
05) Menu Buttons + LED display
06) DMX signal connector (IN) 3-pin
07) DMX signal connector (OUT) 3-pin
08) IEC Power Out (max 10A)
09) Adjustment screw + mounting bracket for Truss mounting

Installation

Remove all packing materials from the LED Lightbar 12 Pixel.
Check that all foam and plastic padding is removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.

Set Up and Operation

Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V p ower, or vice versa.
Connect the device to the main power supply.

Control Modes

There are 6 modes:

One LED Lightbar 12 Pixel ( Built-in programs, Auto Run)

01) Fasten the effect light onto firm trussing or place it on the floor. Leave at least 0,5 meter on all sides
for air circulation.
02) When the LED Lightbar
03) If device is set to
auto run mode. Please see pages 13-14 for more information about the built-in programs or auto run
mode.

One LED Lightbar 12 Pixel (Sound-control)

01) Fasten the effect light onto firm trussing or place it on the floor. Leave at least 0,5 meter on all sides
for air circulation.
02) When the LED Lightbar
03) Turn on the music. If device is set to
music. Please see page 15 for more information about the Sound-controlled mode.
Ordercode: 42197
Built-in Programs
Auto Run
Sound-controlled
Manual control (Static)
Master/Slave
DMX512
is not connected by a DMX-cable, it functions as a stand-alone device.
or , then the fixture will play one of its built-in programs or show its
is not connected by a DMX-cable, it functions as a stand-alone device.
(Audio), then the fixture will react to the beat of the
7
Fig. 01