Control Modes; One Club Par (Built-In Programs, Static Color Mode And Manual Mode); One Club Par (Sound-Controlled); Multiple Club Pars (Dmx Control) - SHOWTEC Club Par 18 Manual

Club Par 18-1 RGB

Control Modes

There are 5 modes:

One Club Par (Built-in programs, Static Color Mode and Manual Mode)

01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) When the Club Par is not connected with a DMX cable, it functions as a stand-alone device.
Please see pages 14 for more information about the Built-in programs, Auto Mode and Manual
Mode.

One Club Par (Sound-controlled)

01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) Turn on the music. If the device is set to sound-control, then the Club Par will react to the beat of the
music. Please see page 14 for more information about the sound-control options.

Multiple Club Pars (DMX Control)

01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Use a 3-pin XLR cable to connect the Club Pars and other devices.
04) Link the units as shown in fig. 03. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX-signal cable. Repeat this process to link the second, third, and fourth units.
05) Supply electric power: Plug electric mains power cords into each unit's IEC socket, then plug the
other end of the mains power cord into proper electric power supply sockets, starting with the first
unit. Do not supply power before the whole system is set up and connected properly.
Ordercode: 42652
• Built-in programs
• Manual Mode
• Static Color
• Sound-controlled
• DMX-512 (3CH or 8CH)
9