About The Engineering Manual; Intended Audience - ABB Relion 670 series Engineering Manual

Section 1
Introduction
1.1.2
1.1.3
4
a reference during periodic testing. The manual covers procedures for mechanical
and electrical installation, energizing and checking of external circuitry, setting and
configuration as well as verifying settings and performing directional tests. The
chapters are organized in the chronological order (indicated by chapter/section
numbers) in which the protection IED should be installed and commissioned.
The Operator's Manual (OM) contains instructions on how to operate the
protection IED during normal service once it has been commissioned. The
operator's manual can be used to find out how to handle disturbances or how to
view calculated and measured network data in order to determine the cause of a fault.
The Engineering Manual (EM) contains instructions on how to engineer the IEDs
using the different tools in PCM600. The manual provides instructions on how to
set up a PCM600 project and insert IEDs to the project structure. The manual also
recommends a sequence for engineering of protection and control functions, LHMI
functions as well as communication engineering for IEC 61850 and DNP3.

About the engineering manual

Use the engineering manual for instructions on how to engineer the IEDs using the
different tools in PCM600.
The engineering manual contains the following chapters:
• The chapter Engineering tool set gives an introduction to the IED protection
and control manager PCM600.
• The chapter Engineering process describes the IED engineering workflow
using PCM600.
• The chapter Setting up a project describes the set up of a typical project in
PCM600.
• The chapter Protection and control engineering describes how different tools
in PCM600 are used to configure protection and control functionality.
• The chapter Local HMI engineering describes the engineering process of the
LHMI.
• The chapter IEC 61850 communication engineering describes the engineering
process to create an IEC 61850 communication configuration.
• The chapter DNP3 communication engineering describes how to use the
DNP3 communication tool.

Intended audience

General
The engineering manual addresses system and project engineers involved in the
engineering process of a project, and installation and commissioning personnel,
who use technical data during engineering, installation and commissioning, and in
normal service.
1MRK511240-UEN B
670 series
Engineering Manual